Isn’t it frustrating to get orange blinking LED after Netgear router setup? Need not to worry! We’ve got you covered! In this post, we’ve mentioned one of the topmost troubleshooting steps that’ll help you in fixing the issue in no time. Let’s take the plunge!
If your Netgear device is unable to connect with your modem, then you will experience blinking orange LED issue on your router. To fix the issue and to get the most out of your Netgear router, restart it once. To power cycle or restart your Netgear router, do the following:
- First things first, unplug your Netgear router but before that disconnect it from your modem.
- Then, wait for 2-3 minutes.
- Plug in your Netgear router back.
- Wait for some time for the power LED on your Netgear router becomes stable.
- Once the power LED on your Netgear router becomes lit and green, connect your Netgear router and modem using an Ethernet cable and check the connectivity between them by accessing the Netgear router login page.
Chances are that you might have ignored the Netgear router firmware update notification and that is the reason why you are facing blinking orange LED on your device. If so, then you need to update the Netgear router’s firmware to the latest version. To update the firmware on your Netgear device, navigate to routerlogin.net page and follow the on-screen instructions.
Configure Your Netgear Router Properly
Sometimes, a partial or incomplete configuration of your Netgear router can also lead to blinking orange LED issue. In order to get the most out of your Netgear router, do the following:
- First and foremost, plug in your Netgear router into a working and damaged-free wall outlet.
- Then, connect your router to the modem using an Ethernet cable. If the Ethernet connection do not work, then you are free to connect your Netgear router and modem in a wireless manner.
- Once you’re done, turn on a PC or laptop and launch a web browser of your choice on it. Bear in mind that the web browser you use must be up-to-date and clear from the load of browsing history, junk files, and unwanted tabs.
- Hover your mouse cursor over the browser’s address bar and enter www.routerlogin.net. Do not use the browser’s search bar for entering the web address. Just in case, the web address does not work, use the default Netgear router IP address instead.
- Follow the on-screen instructions.
Still the Same?
Don’t sweat over it! Last but not the least option to fix Netgear router orange light issue is to reset your device back to factory default settings. Sometimes, a simple resetting of your Netgear router can fix many big issues. But, before resetting your Netgear router, it is suggested to take the back up of your device’s settings including username and password. To reset your Netgear router, follow the steps highlighted below:
- Disconnect your Netgear router from your modem and other connected devices.
- Then, ensure to provide your Netgear router a continuous and uninterrupted power supply.
- Locate the reset hole on your Netgear router.
- Push it gently using a pin or a paper clip.
- Hold the Netgear router reset hole for a few seconds and release it.
- Congrats! You Netgear router has been reset successfully.
- Configure it again by accessing the routerlogin web-based setup page.
Bonus Tip: Refer to the Netgear router manual for instructions to configure your device.
The Bottom Line
We hope that the tips given in this post have proved helpful in fixing Netgear router blinking orange LED issue. In the event that you are still experiencing the same issue, approach us for the solution via comments.